MTP3055VL
6
4
QT
V GS
60
50
40
1000
100
V DD = 30 V
I D = 12 A
V GS = 5 V
T J = 25 ° C
t r
t f
30
Q1
Q2
t d(off)
2
I D = 12 A
T J = 25 ° C
20
10
10
t d(on)
0
0
Q3
2
4
6
V DS
8
0
10
1
1
10
100
Q T , TOTAL CHARGE (nC)
Figure 8. Gate ? To ? Source and Drain ? To ? Source
Voltage versus Total Charge
R G , GATE RESISTANCE (OHMS)
Figure 9. Resistive Switching Time
Variation versus Gate Resistance
DRAIN ? TO ? SOURCE DIODE CHARACTERISTICS
12
10
8
6
4
2
V GS = 0 V
T J = 25 ° C
0
0.50 0.55 0.60 0.65 0.70
0.75 0.80 0.85 0.90 0.95
1.0
V SD , SOURCE?TO?DRAIN VOLTAGE (VOLTS)
Figure 10. Diode Forward Voltage versus Current
SAFE OPERATING AREA
The Forward Biased Safe Operating Area curves define
the maximum simultaneous drain ? to ? source voltage and
drain current that a transistor can handle safely when it is
forward biased. Curves are based upon maximum peak
junction temperature and a case temperature (T C ) of 25 ° C.
Peak repetitive pulsed power limits are determined by using
the thermal response data in conjunction with the procedures
discussed in AN569, “Transient Thermal
Resistance ? General Data and Its Use.”
Switching between the off ? state and the on ? state may
traverse any load line provided neither rated peak current
(I DM ) nor rated voltage (V DSS ) is exceeded and the
transition time (t r ,t f ) do not exceed 10 μ s. In addition the total
power averaged over a complete switching cycle must not
exceed (T J(MAX) ? T C )/(R θ JC ).
A Power MOSFET designated E ? FET can be safely used
reliable operation, the stored energy from circuit inductance
dissipated in the transistor while in avalanche must be less
than the rated limit and adjusted for operating conditions
differing from those specified. Although industry practice is
to rate in terms of energy, avalanche energy capability is not
a constant. The energy rating decreases non ? linearly with an
increase of peak current in avalanche and peak junction
temperature.
Although many E ? FETs can withstand the stress of
drain ? to ? source avalanche at currents up to rated pulsed
current (I DM ), the energy rating is specified at rated
continuous current (I D ), in accordance with industry
custom. The energy rating must be derated for temperature
as shown in the accompanying graph (Figure 12). Maximum
energy at currents below rated continuous I D can safely be
assumed to equal the values indicated.
in switching circuits with unclamped inductive loads. For
http://onsemi.com
5
相关PDF资料
MTP3055VL MOSFET N-CH 60V 12A TO-220
MTP3055V MOSFET N-CH 60V 12A TO-220AB
MTP36N06V MOSFET N-CH 60V 32A TO-220AB
MTP50P03HDL MOSFET P-CH 30V 50A TO-220AB
MTPD1346-010 PIN DIODE 1300NM FLAT 2.8MM TO46
MTPD1346-030 PIN DIODE 1300NM FLAT 2.8MM TO46
MTPD1346-100 PIN DIODE 1300NM FLAT 2.8MM TO46
MTPS1065PT VISIBLE RED POINT SOURCE EMITTER
相关代理商/技术参数
MTP3055VL 制造商:Fairchild Semiconductor Corporation 功能描述:N CHANNEL MOSFET 60V 12A ((NW)) 制造商:Fairchild Semiconductor Corporation 功能描述:N CHANNEL MOSFET, 60V, 12A, TO-220
MTP3055VL_Q 功能描述:MOSFET 60V Single N-Ch RoHS:否 制造商:STMicroelectronics 晶体管极性:N-Channel 汲极/源极击穿电压:650 V 闸/源击穿电压:25 V 漏极连续电流:130 A 电阻汲极/源极 RDS(导通):0.014 Ohms 配置:Single 最大工作温度: 安装风格:Through Hole 封装 / 箱体:Max247 封装:Tube
MTP30N06VL 制造商:MOTOROLA 制造商全称:Motorola, Inc 功能描述:TMOS POWER FET 30 AMPERES 60 VOLTS RDS(on) = 0.050 OHM
MTP30N08M 制造商:MOTOROLA 制造商全称:Motorola, Inc 功能描述:POWER FIELD EFFECT TRANSISTOR
MTP30P06 制造商:MOTOROLA 制造商全称:Motorola, Inc 功能描述:TMOS POWER FET 30 AMPERES 60 VOLTS RDS(on) = 0.080 OHM
MTP30P06V 制造商:MOTOROLA 制造商全称:Motorola, Inc 功能描述:TMOS POWER FET 30 AMPERES 60 VOLTS RDS(on) = 0.080 OHM
MTP30X 制造商:NELLSEMI 制造商全称:Nell Semiconductor Co., Ltd 功能描述:Glass Passivated Three-Phase Bridge Rectifier, 30A
MTP336M060P1C 制造商:Mallory Sonalert Products Inc 功能描述:Cap Tant Wet 33uF 60V 20% (5.72 X 19.76mm) Axial 7.2 Ohm 85°C